Partnership•10 min read
Specification Guide for Architects and Designers
Technical specifications, clearances, and design considerations for pool integration.
Technical Specifications for Pool Integration
This guide provides architects and designers with the technical information needed to successfully integrate commercial pools into building and site designs.
Space Requirements
Pool Vessel
- Minimum deck width: 4 feet (6 feet preferred)
- Competition standard: 25m or 50m lengths
- Lap lanes: 7-9 feet wide (8 feet standard)
- Zero entry: 1:12 slope maximum
Deck Areas
- Deck-to-water ratio: Minimum 2:1, preferred 3:1
- ADA accessible routes: 5 feet minimum width
- Equipment access: 3 feet clearance minimum
- Furniture zones: Additional to circulation
Equipment Rooms
- Minimum 200 SF for residential/small commercial
- 400-800 SF for typical commercial pools
- 1,000+ SF for large aquatic centers
- Height: 10 feet minimum clear
- Access: 3-foot doors minimum, consider equipment replacement
Structural Considerations
Pool Vessel Loads
- Water weight: 62.4 lbs/cubic foot
- Hydrostatic pressure: Varies with depth
- Seismic: Per local requirements
- Soil bearing: Coordinate with geotech
Deck Loads
- Live load: 100 PSF minimum
- Equipment loads: Per manufacturer
- Vehicle access: If required for maintenance
Equipment Room
- Floor drain: Required
- Slab: 4" minimum, reinforced
- Ventilation: Per mechanical code
- Acoustic separation: Recommended
Mechanical Requirements
Water Supply
- Fill: 1" minimum, 2" preferred for commercial
- Pressure: 40 PSI minimum
- Backflow prevention: Required
- Makeup water: Metered
Electrical
- Service: 200-400A typical for commercial
- Emergency: GFCI on all pool circuits
- Lighting: Underwater and deck
- Controls: Automation system
Gas
- Heater input: Size per heating load
- Ventilation: Per manufacturer and code
- Regulator: At equipment
Drainage
- Pool drain: To sanitary or approved disposal
- Deck drain: To storm (check local requirements)
- Backwash: To sanitary
- Equipment room floor drain: Required
Code Requirements Overview
Building Codes
- IBC Chapter 31 (Special Construction)
- Local amendments vary significantly
- Barrier requirements (fencing, gates)
- Emergency egress
Health Codes
- State health department regulations
- Typically based on MAHC or ANSI/APSP standards
- Vary by state—verify early
- Bather load calculations
Accessibility
- ADA requirements (two means of entry for large pools)
- Pool lifts or sloped entries
- Accessible routes and facilities
- Signage requirements
Coordination Points
With Structural
- Pool loads on building structure
- Waterproofing at interfaces
- Expansion joints
With Mechanical
- Dehumidification for indoor pools
- Exhaust for chemical storage
- HVAC for equipment room
With Electrical
- Pool bonding grid
- GFCI protection
- Emergency lighting
- Automation integration
With Plumbing
- Water supply and backflow
- Drain connections
- Gas service
Specification Sections
Pool work typically falls under:
- Division 13 41 00 - Swimming Pools
- Division 13 11 00 - Pool Finishes
- Division 22 - Related Plumbing
- Division 23 - Pool Mechanical
- Division 26 - Pool Electrical
Recommended Early Coordination
Before design development:
- Confirm jurisdiction requirements
- Verify utility availability
- Complete geotechnical investigation
- Engage pool contractor for input
- Establish preliminary budget
Ready to discuss your project?
Contact our team to learn how we can help bring your commercial pool project to life.
