Technical•8 min read

    High-Altitude Pool Construction: What You Need to Know

    Building pools at elevation presents unique engineering challenges from freeze-thaw cycles to UV exposure.

    Building Pools at Elevation

    Constructing commercial pools at high altitude—typically defined as above 5,000 feet—requires specialized knowledge and techniques that differ significantly from sea-level construction.

    The Physics of Altitude

    At elevation, reduced atmospheric pressure creates several challenges:

    Evaporation Rates Water evaporates 20-30% faster at 7,000 feet than at sea level. This affects:

    • Water replacement costs
    • Chemical balance maintenance
    • Heating efficiency
    • Humidity control in indoor facilities

    Boiling Point Depression Water boils at approximately 202°F at 5,000 feet and 194°F at 10,000 feet. This impacts:

    • Heating system design and sizing
    • Hot tub and spa temperatures
    • Equipment specifications

    UV Exposure Challenges

    UV radiation increases approximately 10% for every 3,000 feet of elevation gain. Mountain pools experience:

    • Accelerated material degradation of plastics, rubber gaskets, and covers
    • Faster chlorine breakdown, requiring higher chemical treatment levels
    • Increased fading of colored finishes and painted surfaces

    Solutions:

    • Specify UV-stabilized materials throughout
    • Use covered or shaded chemical storage
    • Consider UV-resistant finishes (tile over plaster)
    • Install automatic chlorinators with UV compensation

    Freeze-Thaw Engineering

    The Mountain West can experience 100+ freeze-thaw cycles annually. This repetitive expansion and contraction stresses:

    Pool Shell

    • Reinforced concrete design must exceed standard specifications
    • Additional expansion joints in long spans
    • Proper curing times (extended at altitude)
    • High-quality waterproofing membranes

    Plumbing Systems

    • Below frost-line installation (4-5 feet in most areas)
    • Proper drainage for winterization
    • Heat tracing on exposed lines
    • Insulation of all accessible piping

    Deck Surfaces

    • Flexible joint materials
    • Proper subgrade preparation
    • Adequate drainage away from pool

    Equipment Considerations

    Standard pool equipment often underperforms at altitude:

    Pumps

    • Reduced air density affects motor cooling
    • May require upsizing by 10-15%
    • Variable speed drives handle altitude better

    Heaters

    • Gas heaters require altitude kits
    • Heat pump efficiency decreases above 6,000 feet
    • Solar heating effectiveness increases due to UV intensity

    Filters

    • Standard sizing usually adequate
    • Consider increased capacity for UV degradation debris

    Best Practices for High-Altitude Success

    1. Work with contractors experienced in mountain construction
    2. Specify altitude-rated equipment from manufacturers
    3. Plan for longer construction seasons
    4. Budget for enhanced material specifications
    5. Implement robust winterization procedures

    Ready to discuss your project?

    Contact our team to learn how we can help bring your commercial pool project to life.

    Infinity Pools

    © 2026 Infinity Pools. All rights reserved.

    Call usStart a project